Baja Designs® 50″ OnX6+ Roof Light Bar Kit fits 18-26 Jeep Wrangler JL/20-26 Gladiator 447666

Put a full 50 inches of Baja Designs light across the roofline of your Jeep Wrangler JL or Gladiator JT with this OnX6+ roof light bar kit. The vehicle-specific brackets run from the cowl up to the roof edge, so the bar sits high and centered with no cutting, trimming or drilling.

The 50″ OnX6+ blends far-reaching high-speed spot reflectors with Baja Designs’ Driving/Combo lens, giving you a long, intense beam that still fills in the trail ahead. This kit (447666) comes with a toggle-switch wiring harness, pre-sized for the Jeep, so it works on trucks without factory upfitter switches.

Why it stands out

• 39,430 raw lumens from 30 LEDs in a single 50-inch bar
• Direct-fit cowl-to-roof brackets made for the JL and JT, in stainless steel with powder coat
• Toggle wiring harness pre-sized for the Jeep; no cutting or drilling required
• IP69K waterproof (submersible to 9 ft and pressure-washable) and IK10 impact rated
• Backed by Baja Designs’ lifetime limited warranty

Kit includes

• (1x) OnX6+ 50″ LED light bar, Driving/Combo, clear lens
• (2x) Vehicle-specific mounting brackets (driver and passenger side)
• (1x) Toggle-switch wiring harness
• All mounting hardware

Fitment

• 2018-2026 Jeep Wrangler JL
• 2020-2026 Jeep Gladiator JT

Not compatible with: Rubicon 392, 4xe, or models with the performance hood. Mojave: Baja Designs notes the roof bar needs longer 80 mm mounting bolts on Mojave models; please confirm fitment with us before ordering for a Mojave.

For Jeeps with factory upfitter switches, Baja Designs also offers this kit with an upfitter harness (447666UP).

Specifications

• Manufacturer: Baja Designs
• Part number: 447666
• UPC: 810031742226
• Light: OnX6+ 50″ LED light bar (30 LEDs)
• Beam pattern: Driving/Combo, clear lens
• Output: 39,430 raw lumens
• Power draw: 355 W / 28.2 A
• Light bar dimensions: 50 x 4.29 x 2.69 in.
• Housing: Aircraft-grade aluminum with Mil-Spec hard anodize; billet machined aluminum bezel
• Lens: Hard-coated polycarbonate
• Bracket and hardware material: Stainless steel
• LED life: 49,930 hours
• Wiring: Toggle-switch harness
• Shipping weight: 42.9 lbs
• Warranty: Lifetime limited warranty

Installation

The brackets bolt on with the included hardware and the harness is pre-sized for the Jeep, so most owners can install it at home. Any roof-mounted light adds some wind noise, depending on the vehicle and accessories installed.